Cutting Table 9' x 30' Water Table Internal Clearance 119" Cutting Width 112" Rail Gauge 129" Plasma Cutting System EPP-200 power supply Positioning Accuracy ± 0.025? Repeatability ± 0.015" Speed Range 2 - 750 ipm Maximum Plasma 1 Maximum Stations 4 Parking Area 36" Machine Height 65" Machine Width 155" Power Requirement 230 VAC, 50/60 Hz, Single Phase, 30 Amp Equipped With PT-600 Torch One Oxyfuel head Vision LE-CFX Columbus Software Link to specs: http://www.practicad.com/docs/ESABShadow2PDS.pdf Has not been under power for two years now, can be put under power if he has a serious offer The cutting table is a 9'X30' water table Plasma Cutting System - Plasma- EPP-200 power supply Torch - PT - 600 One Oxyfuel head Columbus Software Cut primarily carbon steel from 1/4" to 1" with the plasma , and 1 1/2 " and 2" carbon steel with the torch. Cut a small amount of aluminum and SS. No idea on the hours but it was used every week from when it was purchased until Jan or Feb of 2014 when it was shut down. But it was probably used an average of 12-15 hours per week for the life of the time we used it .