Millport Rhino III 2002

The seller bought this machine new about ten years ago. Since then, his business has slowed down and he doesn't get as much use for it. He says it's been running about 10 hours a month, primarily on steel, aluminum, and silver. This machine is fully functional / no defects. It's a 4-axis machine and it's currently under power. Seller says he can send video, along with more specs.Upgrades: The CNC operating system on the Centroid control was updated with the latest software in 2010. Of the features that this machine is equipped with, he says the engraving software, the power draw bar, the 6.5" rotary table, the DP-4 digitizing package and the TT-1 Tool Touch Off were added as upgrades. Also, the servo motors have been replaced and the probe has been re-manufactured.Specs:4-axisTable 50” X 10”Travel Distance X=31.5”, Y=17”, Z=25.6, Quill=5”Spindle Nose to Table = 25.6”Spinle Center to Column = 18”Head Swivel Angle R&L = 90 deg.Motor 3Hp, 208/230 3 phasePrecision ground ball screws X, Y, &ZVariable Spindle Speeds 70-4200 RPMMax Table Load = 1,200 lbsWeight 4,500 lbsSpindle Taper #30 with Erickson Quick Change ThreadWorklightTurcite B lines slidewaysClass 7 Spindle BearingsSquare Ways: Saddle & ColumnCoolant PumpHand-held Jog Pendant60 deg. Angular Contact Bearings for Ballscrews SupportHardene/Ground Table & Way7sTiltable HeadFully Ribbed Meehanite CastingAuto LubeChip Pan & Splash GuearMisterHardwired Limit SwitchesManual HandwheelsMonitor Support Arm with Monitor Stand & Keyboard TrayBase Mount Arm for Monitor SupportNet Gear 15A Network CardRotary Table Troyke 6.5” DL6.5A (Vertical only)Equipped with:-Coolant with pump and mist-Halogen work light-CPG HP-32 Handwheel-Engraving Software-Power Drawbar-Compression Tapping-4th Axis Pre-wire-6.5" Rotary Table-DP-4 Digitizing Package-TT-1 Tool Touch Off-Erickson Quick Change nut-Two draws of tooling