Mitsui Seiki J4DN 1982

Fanuc 6mTsudakoma 12 1/2" Curricular Programable Rotary TableAXISNumber of Axis: 4 POSITIONINGSimultaneous Axis: 3Limits --> X Axis: 23 inches at 90 degree tilt --> Y Axis: 16 inches --> Z Axis: Z quill travel - 7.00 inches Rail Height Max.: 18 inchesRail Height Min.: 6.0 inchesMaximum Z From Top of Rotary Table (90 Degree Tilt) at Rail Height Max: 25.0 inchesMin. Spindle 'Z': 0 inchesC-AXISRotary Table Size: 12.5 inch diameterRotary Table Swing: 8.0 inch radius (from centerline of rotary table)Rotary Direction (gage line to axis center): CLW +Z becomes +Y when going from 0 to 90Feed Rate Minimum: 1 degree/minFeed Rate Maximum: 2000 degrees/minRESOLUTIONLinear: 0.000020 inchesRotary: +/- 5 secondsRepeatability: Linear 0.00004 inch Rotary +/- 2 secondsFEED LIMITMax. Feed: 80.0 inch/minMin. Feed: 0.004 inch/minRapid Traverse: Maximum linear: 200 inch/min Maximum quill: 120 inch/minSPINDLENumber of Spindles: 1Orient/lock Spindle: YesSpindle Tooling Taper: CAT/V flange 40 taperProbing from Spindle: NoMax. Speed: 4500 rpmMin. Speed: 40 rpmIs constant surface feet available: NoIs Spindle Bi-Directional (clw/cclw): YesOTHER NOTESMachine Horsepower (cont. power): 7 Hp. 5.5 Hp. (30 min/continuous)Macro B: YesCoolant Flood: YesCoolant Mist: NoCoolant Thru Spindle: NoTOOLINGProbe Sensor for Tool Set Length: NoPocket Position: RandomMaximum Number Allowed: 99Number of Tools in Changer: 16Length Offset Registers: 50 (1-50)Dia. with All Pockets Full: 6.00 inchesDia. with Adjacent Pockets Empty: 7.00 inchesLength: 13 inch - Automatic tool change 16 inch - Manual tool changeWeight: 35 lb. - Automatic tool change 60 lb. - Manual tool changeTOOL CHANGETool Change Position: HOME X0Y0Z0Preset Tool Lengths Used: NoLength Compensations H-WordCUTCOMMaximum Cutcom Offsets: 39 (51-89) Dia. Compensations: D-WordCan length and dia. comps share the same offsets?: NoCutter Comp Ex: DIACOMP 51 LEFT DIACOMP OFFCutcom Numbering Rules: Tool Number + 50 = Diacomp NumberFIXTURE OFFSETSFixture Offset Numbers: 54-59Are additional axis comps available?: Yes, use G10 commands to set upIs true dynamic fixture comp available I.E. Axis offsets follow rotation: YesMachine '0' Point Location: Floating origin anywhere in working envelopeOTHER INFO.Helical Interpolation (thread/milling) YesPallets Available No